5. trOubleshOOting
sealey group, kempson way, suffolk business park, bury st edmunds, suffolk. ip32 7Ar
01284 757500
01284 703534
www.sealey.co.uk
envirOnMent prOtectiOn
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note
: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Original Language Version
© Jack sealey limited
s
R2000 Issue 1 15/06/18
P
1, P2, P3 indicator lights on the power supply
are not lit.
1) check the power supply.
2) check the input cable.
3) Check the main switch.
4) there is a failure. Please contact the manufacturer.
V
oltage meter display “.000”, when the welder is
turned on.
1) Adjust the voltage control knob on the Welder.
2) Restart the Welder.
3) Trigger on and off several times.
4) there is a failure. Please contact to the manufacturer.
P1 indicator light is not lit.
1) check the power supply,
2) check the input cable.
3) Check the main switch.
4) over heat protection, wait for welder to cool and restart.
s
parks. While steel tab welding
1) check the ground pin for good connection.
2) check the work panel for oxidation or dirt.
3) Lower power setting.
4) increase pressure on ground pins & tabs when welding.
the stud did not weld properly. it can be easily
pulled off of the panel.
1) check stud height adjustment. stud head should be 2-4 mm past
the head of the ground pin.
2) check the ground pin is making good connection.
3) Check the work panel for oxidation or dirt.
4) increase output voltage.
the stud burns through the panel.
1) reduce output voltage.
2) check the work panel for oxidation or contamination.
3) Adjust the gun, reduce pressure.
no output when the trigger is pulled.
1) Check P1, P2, P3 indicator lights. All lights should be on.
2) Check the off/on switch.
3) Check the power supply to the welder.
4) Check the welding stud/tab and the ground pin have good
connection to the panel.
5) there is a failure. Please contact sealey stockist.
