6.4.
NOZZLES (FIG.11)
6.4.1.
Disconnect a nozzle from the spray wand once the cleaning job is complete.
8
DO NOT
expose the nozzle in corrosive liquid.
6.4.2.
Clean the sieve in the water connection
6.4.3.
Clean the sieve in the water connection regularly.
6.4.4.
Remove coupling from the water connection, and rinse with warm water to prevent any foreign matter from clogging the pump.
6.4.5.
Clean the nozzle with the needle clean-out tool provided (fig.12). Remove the spray wand from the gun. Remove any dirt from the
nozzle hole and rinse.
6.5.
MAINTAINING THE SIEVE
6.5.1.
The sieve must not be damaged.
6.5.2.
Pull the sieve out using flat pliers.
6.5.3.
Clean the sieve under running water.
6.5.4.
Reinsert the sieve into the water connection.
7. TROUBLESHOOTING
Symptom
Cause
Recommended action
Machine refuses to start
Machine not plugged in
Defective socket
Fuse has blown
Defective extension cord
Plug in machine
Try another socket.
R
eplace fuse. Switch off other machines.
Try without the extension cord.
Fluctuating pressure
Pump sucking air
Valves dirty, worn out or stuck
Pump seals worn out
Check that hoses and connections are
airtight.
Clean and replace or refer to Sealey stockist.
Clean and replace or refer to Sealey stockist.
Machine stops
Incorrect mains voltage
Thermal sensor activated
N
ozzle partially blocked
Check that the mains voltage corresponds to
specification on the model tag.
Leave the washer for 5 minutes to cool down.
Clean the nozzle
Machine pulsating
Air in inlet hose
Inadequate supply of mains water
N
ozzle partially blocked
Water filter blocked
Hose kinked
Allow machine to run with open trigger until
regular working pressure resumes.
Check that the water supply corresponds to
specifications required
N
B! Avoid using long, thin hoses (min. 1/2”).
Clean the nozzle /Clean the filter
Straighten out hose.
Machine starts, but no water comes out
P
ump/hoses or accessory frozen
No water supply
Water filter blocked /Nozzle blocked
Wait for pump/hoses or accessory to thaw.
Connect inlet water.
C
lean the filter /Clean the nozzle
fig.9
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Original Language Version
© Jack Sealey Limited
fig.10
P
W2000PA Issue 2 (2) 10/02/21
