Sealey Power Products PC3401, Инструкция по эксплуатации

Страница: 5 / 6

6. TROUBLESHOOTING GUIDE
PC3401 Issue No: 1 - 18/07/08
SYMPTOMS REASON REMEDY
Pump does not reach required pressure Nozzle incorrect or worn Replace the nozzle
Dirty filter Clean or replace filter
Air being sucked into the system Check that hoses and fittings are air tight
Water pressure low Check that hoses/fittings are water tight and
tap is fully open
Worn seals Contact Authorised Service Agent
Fluctuating pressure Nozzle worn or blocked Replace the nozzle
Water too hot Reduce temperature
Pump sucking air Check that hoses and fittings are air tight
Water or oil leaks Seals worn Contact Authorised Service Agent
Motor does not start when switched on No electrical power Check plug connections and mains power
supply is active
Automatic cut-off system fault Contact Authorised Service Agent
Motor hums but does not start when switched on Motor/pump jammed Contact Authorised Service Agent
Unsuitable mains voltage Check for adequate power supply and cable
condition
Pump frozen Leave unit to thaw naturally. The pressure
washer should be protected from the threat
of freezing. Extensive pump damage could
otherwise occur (see Section 4.6.5)
Incorrect extension cable Use a suitable extension cable. See Section
1 Elect. Safety
The motor stops Tripped thermal cut-out due to overheating Check that the mains voltage matches the
specifications
Switch off the motor and let machine cool for
3 minutes
No detergent Detergent container is empty Refill detergent container
Detergent pick up body clogged Clear blockage
Injector clogged Clean injector
Nozzle not set to low pressure Move nozzle to low pressure position
Incorrect nozzle fitted Fit correct nozzle (see contents, item 6)
Jet is ineffective, ragged or unsteady High pressure nozzle clogged Clean high pressure nozzle
Selector sleeve for type of jet wrongly set Adjust selector sleeve
Fuse blows in plug Back pressure build up of water causes
machine to draw high amperage
Depress trigger before switching on the
machine
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No responsibility is accepted for incorrect use of this equipment.
WARRANTY: Guarantee is 12 months from purchase, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
7. DECLARATION OF CONFORMITY
Declaration of Conformity We, the sole importer into the UK of Sealey Power Products, declare that the product listed below is in
conformity with the following standards and directives.
The construction files for this product is held by the manufacturer and may
be inspected, by a national authority, upon request to Jack Sealey Ltd.
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
Pressure Washer - Model PC3401
2006/95/EC Low Voltage Directive
2004/108/EC EMC Directive
2006/42/EC Machinery Directive
2000/14/EC Sound Pressure Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
18th July 2008
Signed by Steve Buckle
01284 757500
sales@sealey.co.uk
www.sealey.co.uk
01284 703534
e-mail
Sole U.K. Distributor
Sealey Group
Bury St. Edmunds
Suffolk.
Web