background image

4

Before activating the trigger, GRIP the gun firmly to counteract the recoil from the high pressure water jet.

p

WARNING! 

Avoid sudden bursts of water as these will cause water pressure to drop and put extreme pressure on hoses and connectors.

4

If, during operation, power failure occurs turn the electricity and water off for safety reasons, (see note ‘c’ at end of Section 5).

p

WARNING! 

The high pressure jet will cause loose particles to be propelled at high speed, which may cause serious injury.

p

WARNING!

DO NOT operate the machine without a water supply. Dry running can seriously damage the unit.

p

WARNING! 

DO NOT leave the washer switched on for more than 1-2 minutes without operating the trigger.

8

DO NOT obstruct ventilation grills during operation.

8

DO NOT use the washer with flammable or toxic liquids or any other product. Use only recommended detergent. Unapproved

detergents may corrode the machine cover and accessories. 

8

DO NOT jam the trigger in the operating position.

8

DO NOT adjust any internal control valves, as they have been factory set.

8

DO NOT connect other appliances to the machine inlet or outlet.

8

DO NOT use in damp or wet weather conditions.

8

DO NOT move the unit by pulling the hoses or electrical cables. Use the handle.

8

DO NOT touch plug with wet hands. To avoid the risk of electrocution keep all connections dry and off the ground.

8

DO NOT direct jet against yourself, other persons, animals, electrical equipment or the machine itself. 

8

DO NOT use washer if you are tired or under the influence of alcohol, drugs or intoxicating medication.

8

DO NOT allow children or untrained persons to operate the washer.

p

WARNING! 

Discharge residual pressure before disconnecting the washer hose. Pressure left in unit may cause injury.

4

After use, disconnect washer from electrical mains and water supply and store in a safe, dry, childproof area. 

Manifold Pressure: . . . . . . . . . . . . . . 65bar

Max Pressure: . . . . . . . . . . . . . . . . . 100bar

Effective Cleaning Power:. . . . . . . 1450psi

Water Flow: . . . . . . . . . . . . . . . . . . . . . . . . 

300ltr/hrMotor Power: . . . . . . . . . . . 1200W

Input: . . . . . . . . . . . . . . . . . . . . 230V - 5.2A

Hose Length: . . . . . . . . . . . . . . . . . . . 3mtr

Weight: . . . . . . . . . . . . . . . . . . . . . . . . . 6kg

3.

CONTENTS

1

Lance

2

Gun

3

High pressure hose

4

ON/OFF Switch

5

High pressure hose connector

6

Water inlet (at rear)

7

Detergent dispenser

Unpack the product and check contents against the list below. Also check that the machine has an identification plate or label. If label or parts

are damaged or missing contact your supplier immediately. 

PC1950 - 1 - 190105

Portable and reliable unit ideal for occasional leisure use or as back-up machine. Includes 3mtr hose, lance and foam applicator for pre-wash.

Packed in handy blow mould case with space for all accessories, offering protection and long term storage.

2.

INTRODUCTION & SPECIFICATION

Содержание PC1950








Отзывы: