background image

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions 
and properly maintained, give you years of trouble free performance.

IMPORTANT:

 

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL 

REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE 
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL 
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

 1.  SAFETY 

1.1.   GENERAL

 

Ensure the lamp is fully charged before initial use.

 

DO NOT

 turn the lamp on when it is being charged.

 

DO NOT

 shine directly into your, other person’s or 

 

animal’s eyes.

 

DO NOT 

allow children to use the lamp.

 

DO NOT

 handle or move the lamp whilst it is being  

 

charged.

 

DO NOT

 use the lamp if you suspect that the battery or  

 

the lamp casing is damaged.

 

DO NOT

 leave battery in a discharged state, recharge  

 

battery immediately. Before storage, fully recharge the  

 

battery, subsequently recharge the battery at least once  

 

every six months of non-use. 

1.2.   ELECTRICAL SAFETY FOR USE OF CHARGER. 
 

USE ONLY THE SUPPLIED CHARGER PLUG FOR  

 

CONNECTING LAMP TO THE POWER SUPPLY. 

  

WARNING!

 It is the user’s responsibility to read, 

 

understand and comply with the following electrical  

 

instructions: 

 

You must ensure the risk of electric shock is minimised  

 

by the installation of appropriate safety devices. 

 

An RCCB (Residual Current Circuit Breaker) should be  

 

incorporated in the main distribution board. We also 

 

recommend that an RCD (Residual Current Device) is  

 

used with all electrical products, particularly portable  

 

equipment which is plugged into an electrical supply not  

 

protected by an RCCB. 

 

You must

 also read and understand the following  

 

instructions concerning electrical safety.

 

1.2.1. 

The Electricity At Work Act 1989

  

 

 

requires all portable electrical appliances, if used on  

 

business premises, to be tested by a qualified electrician,  

 

using a Portable Appliance Tester (PAT), at least once a  

 

year.

1.2.2.

 The Health & Safety at Work Act 1974 

makes owners  

 

of electrical appliances responsible for the safe condition  

 

of the appliance and the safety of the appliance operator.  

 

If in any doubt about electrical safety, contact a  

 

qualified electrician. 

1.2.3.

  You must ensure that you:

 

Inspect the charger plug, cable and connector for wear  

 

and damage to ensure items are safe before connecting  

 

to the mains power supply. 

 

If worn or damaged 

DO NOT

 use.

 

Important: Check that the voltage marked on the charger  

 

plug is the same as the lamp.

 

Uncoil the cable between charger and the lamp.

 

DO NOT

 pull the charger plug from the mains socket by  

 

the lead.

  

WARNING! DO NOT use any other type of charger with  

 

this product, other than the supplied mains or car  

 

charger. Failure to observe this warning could result in  

 

injury and or fire and will invalidate the warranty.

 

 

DO NOT

 try to take the charger plug apart.

 

DO NOT

 use the charger plug to charge or power any  

 

other electrical item.

 

DO NOT

 get the charger wet, or use in wet, damp  

 

conditions (for indoor use only).

1.3 

Battery Safety

  

WARNING! To reduce the risk of burns or fire:

 

DO NOT

 Attempt to open, disassemble, modify or 

 

service the battery pack.

 

DO NOT

 

 

Crush, puncture, short external contacts or 

 

dispose of in fire or water.

 

DO NOT

 Expose to temperatures above 60°C (140°).

  

Replace only with the battery pack designated for this 

 

product.

  

Recycle or dispose of used battery as stipulated by local 

 

regulation.

  

If the electrolyte in the cells gets on your skin, thoroughly  

 

wash with soap and water. If it gets in your eyes, rinse  

 

thoroughly with cool water and seek immediate medical  

 

attention

Featuring 35 super bright LEDs, 30 used as an inspection lamp or 5 in the end for use as a directional torch. Single LED battery 
indicator. Two 360° swivel hanging hooks for hands-free applications allowing unit to be used horizontally or vertically. Three 
rubber covered magnets, two magnets on the rear of the lamp for horizontal use and one on the end for vertical use. Bottom 
quarter of the lamp rotates 180° allowing the unit to be positioned for ease of use on any ferrous surface. Replaceable shatterproof 
polycarbonate lens with a highly polished reflector board gives an increased spread of light. Lithium-ion polymer battery 
(3.7V/2000mAh) for longer life, no memory effect, a much slower discharge than typical Ni-MH batteries and can operate for up to 
five hours on a single charge. Supplied with mains and in-car chargers.

Battery: ..............................................................3.7V / 2000mAh 
Charging Time: ..................................................................... 5hrs 
Operating Time: .................................................................... 5hrs 

 2.  INTRODUCTION / SPECIFICATION 

INSTRUCTION MANUAL FOR:

CORDLESS 30 + 5 LED RECHARGEABLE
INSPECTION LAMP LITHIUM-ION

MODEL No.

 

LED3010

Original Language Version

LED3010     Issue: 2 - 20/08/10

Отзывы: