3.
PrEPArinG driLL For uSE
4. oPErAtinG inStructionS
p
WArninG! Ensure you read, understand and apply Section 1 safety instructions.
4.1.
Grip and turn the chuck as indicated in (fig .1) to open the jaws, insert the drill bit full depth,
grip and turn chuck in the opposite direction to close the three jaw chuck and clamp drill bit .
4.2
Connect the drill to the air hose as described in Section 3 .
4.3.
Push the safety catch (fig .1) forward and depress the throttle lever to operate the drill .
fig 3
Original Language Version
GSA232 Issue: 1 - 03/06/13
3.1.
Air Supply
p
WArninG!
Ensure the air supply is clean and does not exceed 90psi while operating
the drill . Too high an air pressure and unclean air will shorten the product life due to
excessive wear, and may be dangerous causing damage and/or personal injury .
3 .1 .1 . Ensure drill air valve (or trigger) is in the "off" position before connecting to the air supply .
3 .1 .2 . You will require an air pressure of 90psi, and an air flow according to specification .
3 .1 .3 . Drain the air tank daily . Water in the air line will damage the drill .
3 .1 .4 . Clean air inlet filter weekly . Recommended hook-up procedure is shown in fig 1 .
3 .1 .5 . Line pressure should be increased to compensate for unusually long air hoses (over 8
metres) . The minimum hose diameter should be 1/4” internal diameter and fittings must
have compatible dimensions .
3 .1 .6 . Keep hose away from heat, oil and sharp edges . Check hose for wear, and make certain
that all connections are secure .
3.2. couplings.
Vibration may cause failure if a quick change coupling is connected directly to the drill . To
overcome this, connect a leader hose to the drill (Sealey ref: AH2R or AH2R/38) . A quick
change coupling may then be used to connect the leader hose to the air line recoil hose .
See fig 2 & fig 3 .
© Jack Sealey Limited 2013
fig 1
fig 2
Safety catch
Grip this section
Turn this section
to open/close jaws
Throttle lever
