background image

MODE 2 10A TYPE 1 TO UK 3-PIN PLUG 
PORTABLE EV CHARGER - 5M CABLE

MODEL NO: 

EVPC1

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these 
instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT:

 PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE 

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1.  SAFETY

1.1.    

ELECTRICAL  SAFETY

 

‰

  

WARNING!

 It is the user’s responsibility to check the following:

 

Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and all  

 

electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical  

 

products. You may obtain an RCD by contacting your local Sealey stockist. 

 

If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable  

 

 

Appliance Test) tested.

 

Electrical safety information: 

 it is important that the following information is read and understood.

1.1.1.   

Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply. 

1.1.2.   

Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.

1.1.3. 

  

Important

: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the    

correct fuse - see fuse rating in these instructions.

 

8

  

DO  NOT

 pull or carry the appliance by the power cable.

 

8

  

DO NOT

 pull the plug from the socket by the cable. 

 

8

  

DO  NOT

 use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or 

             replaced immediately by a qualified electrician.

1.1.4. 

  

This product is fitted with a BS1363/A 13 Amp 3 pin plug. 

      

If the cable or plug is damaged during use, switch the electricity supply and remove from use. 

      

Ensure that repairs are carried out by a qualified electrician.

         

Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.

 

A) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.

 

B) Connect the BROWN live wire to the live terminal ‘L’.

 

C) Connect the BLUE neutral wire to the neutral terminal ‘N

’.

      

Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight. 

        

Sealey recommend that repairs are carried out by a qualified electrician.

1.2.    

GENERAL  SAFETY

 

‰

  

WARNING!

 The charger 

must not

 be used in conjunction with an extension cord, timer or other accessory between wall outlet and  

 charger.

 

‰

  

WARNING!

 Modern vehicles contain extensive electronic systems. You are required to check with the vehicle manufacturer, for any  

  specific instructions regarding the use of this type of equipment on each vehicle. No liability will be accepted for damage / injury,    

 

where this product is not used in accordance with all instructions.

 

8

  

DO NOT

 expose equipment to rain or moisture.

 

8

  

DO NOT

 use if the cables, sockets or unit are damaged.

 

8

  

DO NOT

 start using the equipment if the plugs, cables etc. are dirty or wet. Wipe clean with a dry cloth if necessary

 

8

  

DO NOT

 place the equipment in the car or a confined place when charging.

 

8

  

DO NOT

 expose the equipment to high temperatures.

 

8

  

DO NOT

 clean the equipment with chemical cleaners.

 

8

  

DO NOT

 use whilst under the influence of drugs, alcohol or intoxicating medication.

 

8

  

DO NOT

 pull or carry the unit by its cables.

 

8

  

DO NOT

 use this equipment to perform a task for which it is not designed.

1.2.1.   

The 

Electricity At Work Act 1989 

requires all portable electrical appliances, if used on business premises, to be tested by a qualified  

 

person, using a Portable Appliance Tester (PAT), at least once a year.

1.2.2.   

The 

Health & Safety at Work Act 1974

 makes owners of electrical appliances responsible for the safe condition of the appliance and  

 

the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.

1.2.3.   

Ensure that the insulation on all cables and the product itself is safe before connecting to the mains power supply. 

1.2.4.   

Ensure that cables are always protected against short circuit and overload.

1.2.5.   

Regularly inspect power supply, leads, plugs for wear and damage and power connections to ensure that none is loose.

1.2.6. 

  

Check product voltage is the same as power supply to be used

1.2.7.   

Store the unit in a safe dry environment out of the reach of children.

1.2.8.   

This product does not contain user-serviceable parts, please do not try to repair or maintain the product on your own.

Replacement fuse 

rating: 13A

E

VPC1      Issue 2(4)      27/08/21

Original Language Version

© Jack Sealey Limited

Refer to 

instructions

Electrical shock 

hazard

 

Wear eye 

protection

 Keep in dry area 

protect from rain

 

Warning

Отзывы: