2. INTRODUCTION
Portable mode 2 charger simply plugs into a standard UK 3-pin socket for easy charging. Delay timing function enables users to
program delayed start time to benefit from off peak electricity tariffs. The intuitive LED offers users fault codes, charging time,
power and temperature displays. Supplied with storage case.
3. SPECIFICATION
Model No:.................................................................. EVPC1
Electrical Class: ............................................................... 1ph
Electrical Plug Type: ................................................
3-Pin BS
EV Plug: ...................................................................... Type 1
Current: ..................................................................
10A Fixed
Voltage: ..........................................................................
230V
Cable Length:.................................................................... 5m
C
able Specification:
..............................
3*2.5mm²+2*0.5mm²
IP Rating: ........................................................................IP54
4. OPERATION
4.1.
LED STATE TABLE AND DISPLAY (fig.1)
4.2.
CHARGING
NOTE:
Sealey strongly recommend that an RCD (Residual Current Device) is used
with this unit. You may obtain an RCD by contacting your local Sealey stockist.
4.2.1.
Plug Charger power cable into suitable power supply.
4.2.2.
Remove rubber protection cover from Charger unit cable and fully insert relevant
Charging Cable. Connect cable to EV vehicle.
4.2.3.
Turn the mains power on and the LED interface will light up (fig.1).
4.2.4.
While the equipment is charging, the red light will be permanently on and the green
light will flash (fig.2).
4.2.5.
When charging finishes, Green light will flash, red light is off, disconnect the unit
from the power supply and disconnect the charging connector from the vehicle.
4.3.
TIMER FUNCTION
4.3.1.
With Charger powered up and disconnected from the EV vehicle, press the green button (fig.2) to set the delay time. One press
equals one hour, up to a maximum
delay of 10 hours.
4.3.2.
After time delay is set, connect Charging Cable to charging port on EV vehicle.
4.3.3.
When charging finishes, Green light will flash, red light is off, disconnect the unit from the power supply and disconnect the
charging connector from the vehicle.
5. MAINTENANCE
5.1.
Cleaning and user maintenance should be carried out by competent persons.
5.2.
After use and before performing maintenance, unplug and disconnect the battery charger.
5.3.
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery connectors, cords, and the charger case.
5.4.
Ensure that all of the charger components are in place and in good working condition.
5.5.
Servicing does not require opening the unit, as there are no serviceable parts.
5.6.
All other servicing should be performed by qualified service personnel.
5.7.
If the mains cable is damaged, do not use until repaired.
5.8.
Store in supplied storage case inside a cool, dry place.
Original Language Version
© Jack Sealey Limited
LED Screen
LED State
Fault Yellow
State Green
Charge Red
Rated Current
Ready
O
ff
On
O
ff
Voltage
EV Connected
O
ff
S
low flash
O
ff
Electricity consumption
CP Error
O
ff
Fast flash
O
ff
Charging time
Charging
O
ff
Pulse
On
Power
Charge complete
O
ff
F
lash
O
ff
Constant current
F
ault
F
lash
O
ff
O
ff
E
VPC1 Issue 2(4) 27/08/21
fig.1
fig.2
