4.7.
ATTACHING THE LARGE CARTRIDGE HOLDER (14oz/400g)
NOTE:
Remove the smaller (3oz/85g) cartridge from the grease gun, if applicable. Turn the small cartridge clockwise (left hand
thread).
4.7.1.
Thread the large tube threaded adaptor (fig 2 - 4) into the grease gun housing, by turning it counter-clockwise (left hand thread).
Hand tight only.
4.7.2.
Thread the loaded large cartridge holder into the large tube threaded adaptor (fig 2 - 4).
4.7.3.
Release the follower rod (fig 2 - 1) by pressing on the self-locking latch.
4.8.
PRIMING THE GREASE GUN
4.8.1.
Before loading the grease gun with a cartridge (85g or 400 g), it is ideal to prime the gun.
4.8.2.
To prime the grease gun pack grease into the cavity (where the grease tube screws into the gun) and operate the trigger (fig 3 - 1).
This will induce the intake of grease into the gun assembly.
5. OPERATION
5.1.
To operate the grease gun push the grease coupler (
fi
g 3 - 3) onto the grease nipple and squeeze the trigger (
fi
g 3 - 1) until the
desired amount of grease has been delivered.
5.2.
AIR PURGING
5.2.1.
If you encounter air pockets during operation, or after a new cartridge (85g or 400g) has been installed, exert force on the
follower rod, press the air bleeder valve (
fi
g 3 - 2), and operate the trigger (
fi
g 3 - 1) in short, sharp bursts until grease begins to
fl
ow from the grease couple (
fi
g 3 - 3).
6. MAINTENANCE
6.1.
Use a clean cloth to remove dirt, dust, oil, grease etc.
DO NOT
use solvents to clean the grease gun.
CPG8V Issue 3 13/09/21
Original Language Version
© Jack Sealey Limited
fi
g.2
fi
g.3
