Original Language Version
VS8626 Issue: 1 - 19/07/10
3.2.
Filter Replace
3.2.1. Press the Function button to select the appropriate system
(There is a full list of systems on the rear of the tool).
3.2.2. Press Mode button to select correct type (Filter Replace).
3.2.3. Press the ‘OK’ button to perform the function.
3.2.4. Once the function has completed, the Mode LED will flash to
indicate a successful reset.
3.2.5. If the function is unsuccessful, the 3 System Selection LEDs
will flash.
3.3.
Additive Reset
3.3.1. Press the Function button to select the appropriate system
(There is a full list of systems on the rear of the tool).
3.3.2. Press Mode button to select correct type (Additive Reset).
3.3.3. Press the ‘OK’ button to perform the function.
3.3.4. Once the function has completed, the Mode LED will flash to
indicate a successful reset.
3.3.5. If the function is unsuccessful, the 3 System Selection LEDs
will flash.
3.4.
Regenerate Filter
3.4.1. Press the Function button to select the appropriate system
(There is a full list of systems on the rear of the tool).
3.4.2. Press Mode button to select correct type (Regenerate Filter).
3.4.3. Press the ‘OK’ button to perform the function.
3.4.4. Once the function has completed, the Mode LED will flash to
indicate a successful reset.
3.4.5. If the function is unsuccessful, the 3 System Selection LEDs
will flash.
NOTE:
Regeneration takes around 15 mins in total (2 mins running
at idle, 8 mins at 4000rpm and then 5 mins at idle). Ensure
that rear / exhaust area of the vehicle is kept clear of people
for this period.
Filter Replace
Additive Reset
Regenerate Filter
Note:
As part of the process, a clear codes message will be sent to the vehicle (any faults that are permanent on
the vehicle will remain until the fault is fixed).
(See list on reverse)
(See list on reverse)
(See list on reverse)
