3.2.
To avoid the risk of damage to the vehicle roof, it is recommended that two people lift the roof bars into place.
3.3.
Position the clamps over the roof rails and adjust the bar until it is centrally situated; take care not to let the bar protrude beyond the
outline of the vehicle.
3.4.
Unless the vehicle handbook states differently, space the two bars at least 700mm apart (front to rear).
3.5.
When in position, tighten the clamps (to 6Nm) as in fig.2.
3.6.
The clamps should grip the roof rail as in fig.3.
3.7.
As the inner jaw of the clamp tightens against the rail it will also tighten against the bar, securing it in place.
3.8.
When secure, close the hex key hole shutter by turning the key clockwise and removing.
fig.2
fig.3
fig.4
fig.5
fig.6
4. LOAD SECURITY
4.1.
DO NOT
rely on elasticated fastenings to secure loads to roof bars; use straps.
4.2.
Ensure that any load or attachment is placed centrally or symetrically on the roof bars, with the centre of gravity as low as possible.
4.3.
The roof bars are supplied with 4 x square headed bolts to facilitate the attachment of accessories.
4.3.1.
To attach these bolts, first remove the bar end cap and slide out the filler strip as in fig.4.
4.3.2.
Position the bolts in their intended location (fig.5).
4.3.3.
Cut the filler strip into the required length to fill the top channel on either side of the bolts.
4.3.4.
Slide the bolts out.
4.3.5.
Refill the top channel with the filler strip and bolts in their correct order as in fig.6.
4.3.6.
Refit the end caps and secure the accessory to the bar using M6 nuts (not supplied).
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
may occur. It must be understood by the user that common sense and caution are factors which cannot be built into
this product, but must be applied by the user.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
3. INSTALLATION
3.1.
Before offering the roof bars to the roof rail, open both clamps sufficiently for them to straddle the rail.
3.1.1.
The clamp is opened by inserting the hex key and winding in an anticlockwise direction as in fig.1.
3.1.2.
The hex key opening on the locking clamp is protected by a shutter which is opened by inserting the key and turning anticlockwise.
fig.1
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
ARB120.V3, ARB135.V3 Issue:1 13/11/15
Original Language Version
© Jack Sealey Limited
