AP2060 - 1 - 010507
4
STEP 4
. Next insert the internal partition (7). When in front of the
workstation make sure that the liped side is facing right and the flat
side with the shelf support slot is facing left.
STEP 3
. Attach rear legs (1) and back panel (2) at the same time,
with the same screws. It may be easier to lay the unit down on its
front for this step of the assembly.
3
3.
ASSEMBLY
STEP 1
. To assemble the lower storage area take two large (5. 6)
and two small panels (3, 4) each with six holes and put them
together as shown in the diagram above using 12 screws, 12 nuts
and 12 washers. Make sure that the double bend lips on the larger
panels are facing to the front. Also on panel 3 make sure that the
shelf support slot is facing upwards.
STEP 2
. Next attach the two front legs (1) to the lower storage
area. As shown in the diagram above the legs are retained with
screws, washers and nuts.
1
2
Note! Follow instructions and diagrams to assemble the workstation properly. Pay close attention to the numbered panels and
follow accordingly as some panels have specific uses e.g. some panels have shelf support slots.
