4.2.2.
should the jack become overloaded, a safety excess pressure valve will open and stop the jack from lifting.
warninG!
the jack is a lifting device only and must not be used to support the load. use correctly rated axle stands to support the
load.
4.3.
lowering the vehicle.
warninG!
ensure there are no persons or obstacles beneath the vehicle, or in the path of it’s descent.
4.3.1.
raise the jack high enough for the axle stands to be easily removed. then turn the handle slowly anti-clockwise to open the release valve
(fig.1).
4.3.2.
the lowering speed is controlled by the amount the release valve is opened. lower carefully, avoiding any sudden changes in descent
rate which could shock load the hydraulic system.
5. aSSeMbly - axle StandS
5.1.
insert the centre column into the base frame and stand (fig.2).
5.2.
ensure the toothed side of column will engage with the locking
lever mechanism (fig.3).
5.3.
Bend in locking tab using a drift or similar and a hammer (fig.4).
5.4.
check the base frame and stand is in good condition and has
not suffered damage during transit.
fig.5
fig.1
fig.3
fig.2
fig.4
Original Language Version
3010cX issue:4 - 27/09/16
© Jack sealey limited