3
1. To replace an older toilet, turn off water supply to toilet.
Disconnect water line at toilet water valve. Unscrew floor bolt
nuts and remove toilet. Discard old floor seal and mounting
bolts. The old floor flange may be used if it is in good
condition and has four (4) bolt locations. [Only two bolts are
required for Traveler Lite Model 110.]
NOTE: If old floor flange cannot be used and cannot be
removed, please use a SeaLand Universal Mounting Kit,
available from your SeaLand dealer.
2. When installing new floor flange, make certain that the toilet
mounting bolts align properly with Traveler toilet mounting
pattern.
3. Secure flange to floor using flat head screws through
countersunk holes in flange. Insert floor bolts into slotted holes
in flange (Figure A).
4. If toilet is being installed in a shower stall, apply a 1/4" thick
by 3/4" wide bead of glazing compound around the circumfer-
ence of the floor flange (Figure B).
5. Install seat assembly with hinges and screws provided.
Traveler Models 510/511 will also accept handicap or house-
hold decorative seats. [Traveler Lite Models 110/111 seats
are already installed.]
6. Position floor seal by pressing the floor bolts up through holes
in the seal.
7. Set toilet in place with bolts protruding up through mounting
holes in base (Figure C).
8. Install washers and hex nuts provided with toilet. Snug nuts
down equally with standard 7/16" open end wrench. Remove
excess glazing compound from around base in shower stall
installation. For Traveler Lite Model 110, also install two wood
screws provided in two holes at rear of base. (See Figure C).
9. Connect water supply line to water valve (1/2" MPT) inlet
using appropriate fittings or an extension (Figure D). For
Traveler Lite Model 110, you must remove water valve cover
from flush pedal before connecting water supply line (see instructions below).
10. Turn on water supply and flush toilet to test for leaks.
11. For all models except Traveler Lite Model 110, attach pedestal and pedal covers to toilet base (see installation
instructions below).
PEDESTAL AND PEDAL COVER INSTALLATION
Fig. B
Fig. C
Fig. D
Fig. A
All Traveler toilets
and Traveler Lite
Model 111
(4-bolt connection)
Traveler Lite
Model 110
(2-bolt connection)
Insert
two
wood
screws
in rear
of base.
INSTALLATION
2. Tall model screw
cover together. Short
model snap together.
1. Wrap pedestal cover
around base so that it
closes as shown.
3. Slide pedal cover onto
foot pedal rod.
4. Secure side plate onto
pedal cover with screws.
ALL TRAVELER TOILETS AND TRAVELER LITE MODEL 111:
TRAVELER LITE MODEL 110:
1. Press button on back of
pedal to release water
valve cover.
2. Pull on bottom of cover
to remove it. Cover
snaps back into place.
All manuals and user guides at all-guides.com
