SEAL AquaSEAL SW-5000, Руководство пользователя

Страница: 15 / 24

Section 2. Operating Procedures
14
3. Web the Laminator
A Web diagram is provided in Figure 2-3 below.
Method
1. Ensure that the machine is in Pre-heat mode with the Tension Idler in the Down
position and the Take-up in the DRIVE position.
2. Ensure that Unwind Stands are centered under the media; if the media is fan-
folded, center the media under the front of the machine.
3. Pull media around the back side of the Tension Idler and up between the Tension
Idler and the Web Idler directly above it.
4. Pull material over the top of the Web Idler and under the Draw Down Assembly.
5. Pull the material under the Dryer Panel to the Take-up assembly.
6. From the back of the machine, pull the material square and then tape the edge
securely to the Take-up roller. Make sure that the material is not wrinkled or
misaligned.
Note: It is important to get the material as straight as possible to ensure a
minimal amount of “telescoping” on the Take-up Roller.
Figure 2-3. Web Diagram
Unwind Stands
Media
Tension Idler
Web Idler
Applicator Tube
Draw Down
Assembly
Dryer Panel
Photo Eyes
Take Up
Roller
Sealant
Tank
Sealant
Pump