6
Reset Function
The “Reset Function” allows your erase all configuration and return to
default configuration.
1.
Press and hold the “SET” button.
2.
While pressing the “SET” button, press and hold the “0” button for more
than 3 seconds.
3.
Release both buttons
RESULTS
•
The LED blinks 3 times and extinguishes
•
The remote has been reset
Washing or Cleaning your STV1 Remote
Recent studies have shown the television remote control is one of the
"dirtiest" electronic devices in any household. As a common-touch device
that is handled by everyone in the family, germs on the remote can easily be
transmitted to others. Only Seal Shield™ remotes are both washable, and
also protected by Silver Seal™. Silver Seal™ is an antimicrobial,
fungistatic agent which makes the product greener and fresher by inhibiting
the growth of microbes, odor-causing bacteria, mold, mildew and fungi on
the product’s surface
.
You can easily clean the STV1 remote at any time by spraying it with a
disinfectant spray and wiping it dry with a clean cloth or paper towel. You
can also wash the remote in a sink of warm water using a disinfectant soap,
or you can simply put the remote in the dishwasher on the top rack. We
recommend you remove it before the heat drying cycle and dry it by hand.
Before you put the remote in the sink or the dishwasher, please ensure the
screws that hold the battery cover in place are secure.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. There is no guarantee, however, that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Properly shielded and grounded cables and connectors must be used in order to meet FCC
emission limits. Seal Shield, LLC, is not responsible for any radio or television interference caused by
using other than recommended cables and connectors or by unauthorized changes or
modifications to this equipment. Unauthorized changes or modifications could void the limited
warranty.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
