3
Program by Automatic Code Search
Please read all directions in this section before you begin.
1.
Power on the TV you wish to program the remote to control.
2.
Hold the remote pointed towards the TV. (You must point the remote
towards the TV you wish to control during the “Automatic Code
Search” process.)
3.
While pressing the “SET” button, press and hold the “TV” button for 3
seconds.
RESULTS
•
The remote enters “Automatic Code Search” mode.
•
The “power on/off” signal will be transmitted every 2 seconds for
each manufacture code in the TV device database. After the
“Automatic Code Search” tries all device codes for TV it will exit the
“Automatic Code Search” function.
4.
Once the device powers off, immediately press any button except
“SET” to exit the “Automatic Code Search” mode. Test the remote
control.
RESULTS
•
If the remote controls the TV as expected, you have completed
programming by “Automatic Code Search”.
5.
If the remote does not control the TV as expected, return to step 3 or
follow the instructions in section 1 (Direct Code Input), section 3
(Program by Manual Code Search), or section 4 (LEARN Function
instructions).
6.
To exit the setup mode at any time press the any key except “SET."
Program by Manual Code Search
Please read all directions in this section before you begin.
1.
Power on the TV you wish to program the remote to control.
2.
While pressing the “SET” button, press the “TV” button.
RESULTS
•
The LED will light and remain lit.
3.
Release both the “SET” and the “TV” buttons.
4.
Holding the remote pointed towards the device you wish to control
press the red Power button located at the top of the remote between
the TV and the LEARN buttons.
RESULTS
•
The LED will start flashing to indicate the remote is in “Manual Code
Search” mode.
5.
Keep pressing the Power button at approximately 1 second intervals
until the device reacts by turning off. The “SET” key can be used to
change the code search direction.
6.
Once the device turns off, press the Power button to turn the device
back on.
7.
Test the remote control. While in Program by “Manual Code Search”
mode any keys except “PWR” and “SET” can be used to test the
remote functionality.
