www.seagullmodels.com
27
INSTALLTION PILOT AND CANOPY.
1.
3.
2.
Rudder pushrod.
Elevator pushrod.
1.
2.
4.
3) Secure the tail wheel bracket in place
using two M3 x 12mm wood screws. Be care-
ful not to overtighten the screws.
1) Set the tail wheel assembly in place on
the plywood plate. The pivot point of the tail
wheel wire should be even with the rudder
hinge line and the tail wheel bracket should
be centered on the plywood plate.
2) Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Cut.
M3 x 12mm.
2
1
2) A scale pilot is included with this ARF. The
Seagull Pilot included fitting well to the cockpit.
(or you can order others scale pilot figures
made by Seagull factory. They are available at
Seagull distributors.)
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the figure
so that it is flat.
1) Locate items necessary to install pilot,
cockpit panel, and canopy.
Epoxy.
3.
2.
10mm.
3) Position the pilot figure on the canopy floor
as show. Locate the oval shaped on the canopy
floor and remove the covering. Use epoxy to
glue this into the base of the pilot figure and
glue the cockpit panel in place with C/A glue,
please see pictures as shown.
C/A glue.
