Seagull Models YAKOVLEV YAK 3 ARF, Инструкция по сборке

Страница: 33 / 36

33
BALANCING.
1) It is critical that your airplane be
balanced correctly. Improper balance will
cause your plane to lose control and
crash. THE CENTER OF GRAV-
ITY IS LOCATED
160MM
BACK
FROM THE LEADING EDGE OF
THE WING AT THE WING ROOT.
3) With the model inverted, place your
fingers on the masking tape and carefully
lift the plane.
Accurately mark the balance point on
the top of the wing on both sides of the
fuselage. The balance point is located
160mm back from the leading edge of
the wing at the wing root. This is the bal-
ance point at which your model should
balance for your first flights. Later, you
may wish to experiment by shifting the
balance up to 10mm forward or back to
change the flying characteristics. Mov-
ing the balance forward may improve
the smoothness and arrow- like tracking,
but it may then require more speed for
take off and make it more difficult to slow
down for landing. Moving the balance aft
makes the model more agile with a light-
er and snappier ”feel”. In any case,please
start at the location we recommend .
2) Mount the wing to the fuselage. Using
a couple of pieces of masking tape, place
them on the top of the wing
160mm
back
from the leading edge of the wing at the
wing root.
With the wing attached to the fuselage,
all parts of the model installed ( ready to
fly), and empty fuel tanks, hold the mod-
el at the marked balance point with the
stabilizer level.
Lift the model. If the tail drops when
you lift, the model is “tail heavy” and you
must add weight* to the nose. If the nose
drops, it is “nose heavy” and you must
add weight* to the tail to balance.
*If possible, first attempt to balance the
model by changing the position of the re-
ceiver battery and receiver. If you are un-
able to obtain good balance by doing so,
then it will be necessary to add weight to
the nose or tail to achieve the
proper balance point.
Epoxy