RENO AIR CARE YAK-11 “PERESTROIKA”
Instruction Manual.
28
5) When you are sure that everything
is aligned correctly, mix up a gener-
ous amount of Flash 30 Minute Epoxy.
Apply a thin layer to the mounting slot
and to bottom of the vertical stabilizer
mounting area. Apply epoxy to the bot-
tom and top edges of the filler block and
to the lower hinge also. Set the stabilizer
in place and realign. Double check all of
your measurements once more before the
epoxy cures. Hold the stabilizer in place
with T-pins or masking tape and remove
any excess epoxy using a paper towel and
rubbing alcohol. Allow the epoxy to fully
cure before proceeding.
Hinge.
C/A glue.
1) Install the elevator control horn using
the same method as with the aileron con-
trol horns.
2) Position the elevator control horn on
the both side of elevator.
ELEVATOR PUSHROD HORN
INSTALLATION.
Elevator control horn.
Fuel tubing.
3) Thread one clevis and M2 lock nut on
to each elevator control rod. Thread the
horns on until they are flush with the
ends of the control rods.
4) Elevator and rudder pushrods assem-
bly as pictures below.
Hex nut.
Elevator pushrod.
M2 clevis.
2
.
3
.
4
.
5
.
1
.
8
.
M2 clevis.
M2 lock nut.
