RACER DELTA 40-46
Instruction Manual.
24
3) Position the pilot figure on the cock-
pit floor as shown. Use epoxy to glue the
base of the pilot figure, please see pictures
as shown.
Epoxy.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and
aid in their location.
APPLY THE DECALS.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
BALANCING.
1) It is critical that your airplane be
balanced correctly. Improper balance will
cause your plane to lose control and
crash. THE CENTER OF GRAV-
ITY IS LOCATED
220MM
BACK
FROM THE LEADING EDGE OF
THE WING AT THE WING ROOT.
2) Mount the wing to the fuselage. Place a
piece of masking tape on the top of each
wing 220mm back from the leading edge
at the wing root.
3) With the model inverted, place your
fingers on the masking tape and carefully
lift the plane. This is the point at which
your model should balance for your first
flights. Later, you may wish to experi-
ment by shifting the balance up to 10mm
forward or back to change the flying
characteristics. Moving the balance for-
ward may improve the smoothness and
arrow- like tracking, but it may then re-
quire more speed for take off and make it
more difficult to slow down for landing.
Moving the balance aft makes the model
more agile with a lighter and snappier
”feel”. In any case, please start at the loca-
tion we recommend.
With the wing attached to the fuselage,
all parts of the model installed ( ready to
fly), and empty fuel tanks, hold the mod-
el at the marked balance point with the
stabilizer level.
Содержание RACER DELTA 40-46
Страница 7: ...7 INSTALLING THE MAIN LANDING GEAR TO FUSELAGE ...
Страница 9: ...9 14 5mm M3 clevis M3 lock nut 16 6mm ...