NEMESIS-114
Instruction Manual
6
See pictures below:
ENGINE MOUNT INSTALLATION.
Mark and drill 4 holes for engine mount.
Insert 4 blind nuts to firewall.
4x30mm.
Thread locker glue.
2) Using a modeling knife, cut one length
of silicon fuel line. Connect one end of the line
to the weighted fuel pick up and the other end
to the nylon pick up tube.
3) Carefully bend the second nylon tube
up at a 45º angle. This tube is the vent tube.
1) Using a modeling knife, carefully cut
off the rear portion of one of the 3 nylon tubes
leaving 1/2” protruding from the rear of the
stopper. This will be the fuel pick up tube.
INSTALLING THE STOPPER ASSEMBLY.
Silicon tubing not inclued.
1
2
RUDDER CONTROL HORN
INSTALLATION.
Rudder control horn:
Using the same techniques used aileron
control horn. See picture below.
65mm.
Hinge.
Hudder control horn.
