EXTRA 300.
Instruction Manual.
8
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
Install the rubber grommets and brass
collets onto the aileron servo. Test fit the
servo into the aileron servo mount.
!
1) Install the rubber grommets and brass
eyelets onto the aileron servo.
!
2) Install the metal connector onto servo
arm.
!
3) Turn the wing panel right side up. Using
a modeling knife, remove the covering at servo
tray.
!
2) While keeping the back edge of the
cowl flush with the marks, align the front of
the cowl with the crankshaft of the motor. The
front of the cowl should be positioned so the
crankshaft is in
nearly
the middle of the cowl
opening. Use the spinner backplate as a guide.
Hold the cowl firmly in place using pieces of
masking tape.
3x10mm.
!
3) Slide the cowl back over the motor.
The propeller should not touch any part
of the spinner cone. If it does, use a sharp
modeling knife and carefully trim away the
spinner cone where the propeller comes in
contact with it.
AILERON SERVOS - LINKAGES.
Servo(2pcs).
Small weight.
Thread.
