EXTRA 300.
Instruction Manual.
10
!
2) Install the rubber grommets and brass
collets onto the elevator servo. Test fit the
servo into the elevator servo mount.
!
3) Secure the servos with the screws pro-
vided with your radio system.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
INSTALLING THE SWITCH.
Install the switch into the precut hole in the
side, in the fuselage.
Right side.
Elevator servo.
Left side.
Rudder servo.
HORIZONTAL STABILIZER.
!
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
Remove covering.
Switch.
Center line.
Repeat the procedure for orther wing
haft.
!
1)
Locate and cut out the covering film from
the servo holes in both sides of fuselage.
FUSELAGE SERVO INSTALLATION.
Right side.
Remove
covering.
Repeat the procedure for rudder servo.
