AT 6 - TEXAN.
Instruction Manual.
7
8) After both ailerons are securely hinged,
firmly grasp the wing panel and aileron to
make sure the hinges are securely glued and
cannot be pulled out. Do this by carefully
applying medium pressure, trying to separate
the aileron from the wing panel. Use caution
not to crush the wing structure.
Note:
Work the aileron up and down several
times to “work in” the hinges and check
for proper movement.
7) Repeat this process with the other wing
panel, securely hinging the aileron in place.
6) Using C/A remover/debonder and a
paper towel, remove any excess C/A glue that
may have accumulated on the wing or in the
aileron hinge area.
Repeat the procedure for the other wing
half
.
INSTALLING THE MAIN GEAR WIRES
MAIN LANDING GEAR
INSTALLATION ( OPTION I ).
1) Using a modeling knife, remove the cov-
ering from over the two main gear mounting
slots located in the bottom of the wing. One
slot is located in each wing half.
2) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
3) The landing gear wire is held in place
using two nylon landing gear straps and four
3mm x 12mm wood screws.
NOTE
: The straps should be located equal
distance from the inside and outside ends of
the wire.
4) Using the two landing gear straps as a
guide, mark the locations of the four 3mm x
12mm mounting screws onto the wing sur-
face.
5) Remove the two straps and the gear
wire. Drill four 1mm pilot holes into the wing
for the wood screws.
Be careful not to drill through the top of
the wing!
3mm x 12mm.
Remove covering.
