Seagate ST750LM000, Руководство по эксплуатации продукта

Страница: 25 / 34

Seagate Laptop SSHD SATA Product Manual, Rev. M 24
Serial ATA (SATA) Interface
6.0 Serial ATA (SATA) Interface
These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes
0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6. The drive also supports the use of the IORDY signal to provide reliable high-speed data
transfers.
For detailed information about the Serial ATA interface, refer to the Serial ATA: High Speed Serialized AT Attachment specification.
6.1 Hot-Plug Compatibility
Seagate Laptop SSHD SATA drives incorporate connectors which enable users to hot plug these drives in accordance with the Serial ATA: High
Speed Serialized AT Attachment specification revision 2.0. This specification can be downloaded from www.serialata.org . This device requires a
COMRESET from the host after a hotplug event.
6.2 Serial ATA Device Plug Connector Pin Definitions
Table 10 summarizes the signals on the Serial ATA interface and power connectors. Refer to the Notes below.
Notes
1 All pins are in a single row, with a 1.27 mm (0.050 in) pitch.
2
The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
3
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane
configuration.
4
All used voltage pins (V
x
) must be terminated.
Table 10 Serial ATA Connector Pin Definitions
Segment Pin Function Definition
Signal
S1 Ground 2nd mate
S2 A+
Differential signal pair A from Phy
S3 A-
S4 Ground 2nd mate
S5 B-
Differential signal pair B from Phy
S6 B+
S7 Ground 2nd mate
Key and spacing separate signal and power segments
Power
P1 V
33
3.3V power
P2 V
33
3.3V power
P3 V
33
3.3V power, pre-charge, 2nd mate
P4 Ground 1st mate
P5 Ground 2nd mate
P6 Ground 2nd mate
P7 V
5
5V power, pre-charge, 2nd mate
P8 V
5
5V power
P9 V
5
5V power
P10 Ground 2nd mate
P11 Ground or LED signal If grounded, drive does not use deferred spin
P12 Ground 1st mate
P13 V
12
12V power, pre-charge, 2nd mate
P14 V
12
12V power
P15 V
12
12V power