68
Barracuda 2LP Product Manual, Rev. D
11.6
DC cable and connector
Note. This section applies only to N/ND/W/WD models. WC and DC models
do not have a 4-pin power connector and do not use DC power cables.
The drive receives DC power through a 4-pin connector mounted at the rear
of the main PCB. Recommended part numbers of the mating connector are
listed below, but equivalent parts may be used.
Table 13. Mating connector parts
Type of cable
Connector
Contacts (20-14 AWG)
14 AWG
AMP 1-480424-0
AMP 60619-4 (loose piece)
AMP 61117-4 (strip)
Note. The output of a power supply must meet SELV (safety extra low
voltage) as defined in IEC 950.
Pins
1
+12V DC
2
+12V DC return
3
+5V DC return
4
+5V DC
11.7
SCSI physical interface
Figures 26, 27, and 28 illustrate the physical interface on Barracuda 2LP
drives. Locations of the DC power connector, the SCSI interface connector,
and the drive select and option select headers are shown.
Details of the physical, electrical, and logical characteristics are given below.
The SCSI operational aspects of Seagate drive interfaces are provided in the
SCSI-2 Interface Product Manual.
J2
J4
SCSI I/O
Connector
DC Power
Connector
ST31250N and
ST32550N
J1 Connector
ST31250ND and
ST32550ND
J1 Connector
Figure 26. ST31250N/ND and ST32550N/ND physical interface
1
2
3
4
Содержание BARRACUDA 2LP
