7
COMMON QUESTIONS AND ANSWERS
Q:
The Validator Lights is not green
A:
Check the power source.
Unplug the ChangeMaker, then wait one (1) minute and plug in. (This action will "reset" the ChangeMaker.)
The bill validator will make a brief noise indicating it is running after reset.
Check the Wire Harness to make sure it is plugged in to the Bill Validator.
Check the level of coins in the Coin Hopper.
Check for jammed coin or bill. (See Clearing Jams)
Check the Wire Harness plug that connects the Coin Hopper.
Q:
How do I remove a jammed bill?
A:
Open the Bill Validator (see Removing The Bill Validator) and remove the jam.
Q:
Bill will not feed into, or is not accepted by the Bill Validator.
A:
Make sure that the bill is not soiled, damaged or defaced.
Check for a jammed bill (See Clearing Jams)
Clean the Bill Validator.
If green lights is off, unit may be low on coins.
Q:
My ChangeMaker is dispensing the wrong amount of coins.
A:
Make sure that the coins are not damaged, obstructed or stuck together.
Check to make sure your settings are correct, see Setting Service
Q:
Validator runs constantly.
A:
Contact Seaga Customer Care.
