5
Figure 3 – Rails
LOADING CURRENCY
CAUTION: Turn off and unplug your ChangeMaker before loading or you could damage
your hopper and void your warranty!
The Coin Hopper holds your quarters (or tokens) in bulk. To load, pour quarters into the Coin Hopper until full. When
full and ready to accept bills, the green light on the lower left front of the Coin Hopper is lit and the LED Display shows
“Insert Bill”.
CAPACITY
Your ChangeMaker has a change capacity of $250.
BILL RETRIEVAL
Accepted bills are stored in the Bill Tray over the hopper assembly. The bill tray can be removed by sliding it forward.
Be aware that bills will land in different positions and may pile up. You will want to be familiar with your location and
service the machine to remove bills before they create jams.
LED MESSAGES
The “NO COINS” message will be displayed when there are approximately 20 quarters or less in the Coin Hopper. If
your Coin Hopper has plenty of quarters and the No Coins message is displayed, unplug the ChangeMaker for about
one (1) minute to reset.
Your ChangeMaker also shows messages when dispensing coins, for example, $1 = 4 Qtrs when changing a $1 bill.
When in full operational mode and ready to make change, the message displayed is “Insert Bill”.
CLEANING
The Coin Hopper may need to be cleaned periodically. To clean, you may either blow out the hopper with canned air,
which can be found in office and computer supply stores or remove the hopper assembly and shaking any dust or
debris out. Do not use liquids or chemicals on the Coin Hopper or on any part of the Bill Validator!
REMOVING THE BILL VALIDATOR
In the event that you need to replace your Bill Validator, your ChangeMaker is designed for easy replacement.
To Remove the Bill Validator.
a. Unplug the ChangeMaker.
b. Unlock and open the Front Door.
c. Unplug the Wire Harness from the left side of the Bill Validator (Fig. 4)
d. Press the Release Lever on the Bill Validator and lift it toward the Coin Hopper
e. Slide the Bill Validator up to remove
Latch
