950-0207revA - 13 - November 27, 2013
CLEARANCES AND MOUNTING REQUIREMENTS
> .
2 ft
> .
.
3 3 ft
>
.
1 ft
>
2 ft.
>
5
f
t
.
>
.
1
ft
>
2 ft.
>
.
2 ft
>
.
5 ft
>
.
.
7
6
ft
PO
WER
RUN
TIMER
SELECTING LOCATIONS FOR THE INDOOR UNIT
1. Obstruct should be take away from the inlet or outlet of the indoor unit so that the airflow can be
blown though all the room.
2. Ensure the installation is done as per the clearance and mounting requirements shown in Figure 2
above.
3. Ensure the hanger is strong enough to withstand the weight of the unit.
4. Ensure the installation place is at horizontal level.
5. The drainage pip is easy for connection.
6. The unit should be installed far away from where is heat source, leakage of inflammable, explosive
substances, or smog.
7. The installation is convertible between stand and ceiling.
8. The power cords and connection lines of the indoor and outdoor units must be at least 3.3 ft. away
from the TV set or radio to avoid the image interference and noise (even if 3.3 ft. is kept, the noise
may be produced due to the strong electromagnetic wave).
INSTALLING THE INDOOR UNIT
To install the unit on the ceiling or stand on the floor has the similar installing procedure as follows:
1. Determine the mounting position on ceiling or wall by using paper pattern to indicate indoor frame.
Mark the pattern and pull out the paper pattern. See Fig. 3 on next page.
Figure 2
.
