SEABOB CAYAGO F7, Руководство по эксплуатации

Страница: 55 / 82

| P
age 55
|
SEABOB
Operation
Manual
|
5
6. Turn the grips of the quick clamps anticlockwise at
the same time on both sides of the accumulator box.
Doing this will push the SEABOB away from the ac-
cumulator box.
Caution! Beware of possible sharp edges on the
locking clamps. For technical reasons, sharp edg-
es created during manufacture may be present on the
locking clamps. Sharp edges may cause minor injuries to
fingers, fingernails and other body parts, especially if you
are not used to using the locking clamps.
7. Slide the rear of the SEABOB housing backwards a
maximum of approx. 10 cm until the accumulator box
ACS is detached from the SEABOB housing.
Never slide the SEABOB completely backwards
over the accumulator box. If this is done, the quick
clamps may damage the housing in the accumulator
shaft.
8. Holding on to the carrying handles on each side, lift
up the SEABOB housing off the accumulator box.
9. Store the accumulator box ACS in a place that is cool,
dry, well ventilated and frostproof.
Note: Without the accumulator box ACS, the SEABOB
ACS is fully deactivated and non-functional.
Never expose the SEABOB, the accumulator box
and the charger to high temperatures (max. 60 °C /
140 °F) caused e.g. by open fire, direct sunlight or by stor-
age inside a closed motor vehicle or boot. If exposed to
heat, flaming gases can be discharged through the ac-
cumulator cells‘ safety valve causing serious injury. In ad-
dition, the LCD display will turn black if exposed to heat
and may become irreparably damaged.
5.12 Storing the SEABOB and accumula-
tor box ACS
If you do not plan to use the SEABOB / accumulator box
ACS for an extended period, the accumulator box must be
stored at least in a partial charge state (charge state "air
transport / storage"). The minimum charge state during
storage is required to prevent irreparable total discharge
of the valuable Li-Ion accumulator cells and to ensure
that the microprocessor-controlled Cell-Balance function
remains active. You may have to recharge the accumu-
lator box, depending on its charge state. The charging
process is controlled automatically by the charger and
accumulator management system.
Be sure to read the information contained in Chapter 5.2
"Charging the accumulator box".
To prepare the device for storage, proceed as fol-
lows:
1. Place the SEABOB and accumulator box on a dry and
sturdy surface that will not damage the components.
2. Ensure that the charging plug, charging socket and
mains plug are perfectly clean and dry. If necessary,
dry them using a soft, clean cloth.
3. Plug the charging plug of the charger into the charg-
ing socket of the accumulator box. Then plug the
mains plug of the charger into the mains socket.
4. The charge display will appear on the SEABOB af-
ter 15 seconds (system check). The device is now in
Charge mode.
5. Tap the green button to select partial charging of the
accumulator box to charge state "air transport / stor-
age". A partially filled charge symbol will appear on
the upper left-hand side of the display with an arrow
to indicate partial charging.
6. When the aircraft symbol appears on the display and
the remaining charging time is displayed as "0:00",
partial charging is complete and the minimum charge
state for storage has been reached. You can now dis-
connect the charger from the accumulator box (first