5.10. Built-In Furniture
All upholstery material for berths, settees and seats will be supplied by the Builder.
Builder will be responsible for supplying the mattress and cushion material and will be
responsible for fitting the upholstery with zippers and tufting as required.
All berths to be fitted with lightweight drawers and/or lockers under, as per plans and
with removable bunk bottoms for access. Bunk bottoms to be foam or honeycomb
cored. Berths to have fiddles, high enough to retain mattress, but in no case to have
tops of fiddles higher than 50mm below top of mattress. Owner's and guest berth
mattresses shall be 150mm thick foam, crew berth mattreses to be 100mm thick. All
mattresses to have covers of upholstery material supplied by the Builder. All mattresses
to have full-length nylon zippers of best quality, on at least two sides. Berths to be fitted
with Dacron lee-cloths with padeyes in overhead and lightweight tackles for tensioning
or lee boards as selected by the Owner.
The Builder shall install settees and seats as shown. Cushions to be 120mm thick with
built up lip. Counter tops and shelves to be fitted with fixed fiddles as directed. No
fiddles required on saloon table.
5.11. Curtains
Curtains to be provided for the windows, as directed and approved by the builder, with
material as supplied by the Builder. Blinds to be provided for coachroof windows, as
approved by the Builder. Curtain hangers to be approved by the Builder.
5.12. Portlights and Windows
Interior window detailing to be cohesive with adjoining joinerwork.
5.13. Deckhead/Overhead
Panels to be of lightweight construction. Generally, 4mm plywood panels upholstered
with Alcantara or Majilte fabric, as approved by the Builder. Panels to be mounted with
velcro and fitted so as to permit easy access to the underside of the deck.
5.14. Hatches
Custom main companionway hatch to have lightweight composite panel with lexan
window insert, on stainless steel sliders and composite or lexan washboards. If the
arrangement allows, the washboards will drop into cockpit well.
Interior finish of deck hatches to be of molded composite trim that is finished to match
cabin. Molding to have integral rebate to house the OceanAir sky screen.
5.15. Cabin Sole
Cabin soles throughout, are to be 2mm thick wood (TBD) veneer on 15mm balsa core
with 4mm plywood faces. Care to be taken when laminating floorboards to avoid
warping. All edges to be back-beveled at 5° to prevent binding as per drawings. All sole
panels are to be edged with solid teak or other suitable matched hardwood. Skirting
trim, as per drawings, to be fitted around all edges of vertical joiner pieces. All cabin
soles to have 2mm thick rubber gaskets on the under side to minimize noise
transmission. Insulation to be used in way of equipment mounted under sole panels.
17
