SEA TAURUS CHAIN, Инструкция по эксплуатации

Страница: 8 / 16

Plinth
Fig. 6
DIMENSIONS
(inches)
2. FOUNDATION PLATE ANC ORING
(Only for TAURUS RACK version)
To install the foundation plate proceed as follows:
2.1. Prepare a concret basement with the dimensions
shown in Fig. 6 where the foundation plate and the
anchoring bolts will be cemented.
NOTE : It is recommended gate structure permitting
to lift the foundation plate about , 6 inches from the
ground, in order to avoid eventual water stagnation
2.2. Before cementing the plate insert a flexible plastic
duct of at least , inches in diameter into the special
hole of the plate.
2.3. Before cementing the plate, make sure that it’s
perfectly leveled and that the distance of 2,4 - 2,67
inches as shown in Fig. 7 is respected
1. TYPE OF INSTALLATION
Only a head-on installation of the operator is
permitted it is highly recommended to install two
security gate stops on the two extremities of the rail to
prevent the gate from derailment Fig. 5
Fig. 5
O er-Tra el Stop
O er-
Tra el
Stop
EC ANICAL INSTALLATION
590
16 53
9 84
3
Fig. 7
16
20
3,93 in.
4,25 in.
2 44 in.
2 48 - 2 67 in.
«Q» MINIMUN
DIMENSION
Q
3. CA LES PASSAGE ARRANGEMENT
TAURUS is provided with seven holes for electric
cables passage.
Important: Always run main carrying cables 20
in separate holes to low voltage cables 24 - Fig.
4. FITTING OF T E MOTOR
(Only for TAURUS RACK version)
4.1. Insert the 4 grub screws into the special holes for
the adjustment of the motor height on the plate
Fig.
At the end of installation check if the 4 grub
screws are well gripped on the foundation plate
4.2. Fix the motor on the foundation plate with the 2
included nuts, adjusting the side position Fig. 20 so
to respect the quota shown in Fig. 7
Fig.
Fig.
8