SEA SYSTEMS
INSTALLATION AND USE
STK1R control panels (Setronik1 Restyling)
STK1R-EN-62-0-A
rev0
24/01/2019
0.10 | 0.11 Setting the maintainer password
To prevent modification of the parameters by unauthorized persons, the maintainer can set a protection
password.
Set the password (four hexadecimal digits, 0 … 9, A … F) in 0.10.0 and confirm it in 0.11.0, then save it with
0.12. Set “0000” or “FFFF” if you want to remove the protection (no password will be asked).
[0.10.0]
First password entry
DG0
DG1
DG2
DG3
DG4
DG5
DG6
0 1 0
[0.11.0]
Second password entry
DG0
DG1
DG2
DG3
DG4
DG5
DG6
0 1 1
0.12 Storing the parameters
DG0
DG1
DG2
DG3
DG4
DG5
DG6
0 1 2 0 0 0
[0.12.0]
To store permanently the parameter, set the cursor on DG3456 and press the ˄ push-button. One of
the following results will be shown:
DG6
R
ESULT
2
The parameters have been stored correctly
3
The parameters have not been stored. Try to repeat the procedure
LOSS OF PARAMETER SETTINGS
This parameter makes the modified parameters permanent. If this operation is not performed, the
parameter settings will be lost if the power to the STK1R board is cut off.
© 2019
Sea Systems
Page 30 of 99