Sea Tel ST24, Руководство по эксплуатации и установке

Страница: 16 / 101

Installation ST24 Ku-Band TVRO
3-10
Locate and disengage the Azimuth Stowage lock.
Refer to the Maintenance section of this manual
for complete procedures to stow and un-stow your
antenna.
Perform range of motion check on antenna.
Verify free range in Azimuth, Elevation and Polarization drive.
3.7. Graphic Antenna Control Panel
Label, Connect, and Secure the Antenna M&C
Coax (from Above Decks) to the RF In port of
the GACP.
Connect and secure the DC Power Cable
Assembly or the optional DC Power Switch
Cable Assembly onto the “BATT” connector of
the GACP.
Carefully remove GACP front lid to provide access to the four mounting holes.
Use caution as to not damage or pull out the “COM 0” interface harness that interconnects the display
module PCB to the controller PCB.