Sea Tel 6009-33, Инструкция по установке и эксплуатации

Страница: 23 / 95

Set-up & Configuration 6009-33 Broadband At Sea
4-5
4.7. TRACK DISP
This parameter set the selections that the user will see in the Tracking - Band Selection menu. Band Selection must be
set to the appropriate selection for Tracking to operate properly.
The Band selection controls the local logic output state of SW1 output terminal on the Terminal Mounting Strip PCB,
the LNB voltage supplied by the pedestal modem, and the remote Aux Status (Co-Pol/Cross-Pol receive IF Coax
switch) on the antenna pedestal.
The factory default selections and SW1 status for your antenna is listed in the following table:
TRACK
DISP
Setting Displayed band
selection ADE Band Select Parameters
(Tone, Voltage & Aux Status) TMS SW1
Status
0130 Xp B1
Xp B2
Xp B3
Xp B4
Cp B1
Cp B2
Cp B3
Cp B4 Tone OFF, Volt 13, Aux 0
Tone ON, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone ON, Volt 18, Aux 0
Tone OFF, Volt 13, Aux 1
Tone ON, Volt 13, Aux 1
Tone OFF, Volt 18, Aux 1
Tone ON, Volt 18, Aux 1 Open
Open
Short
Short
Open
Open
Short
Short
When the SW1 output is shorted to ground a current sink of 0.5 amps max is provided to control below
decks band selection tone generators or coax switches. When SW1 output is open it is a floating output.
PRELIMINARY