2
1A
Install the Fixture
FIXTURE
LAMP
DIFFUSER
1
2
3
4
5
6
7
8
9
CHANNEL
COVER
Remove channel cover by squeezing at each end in the xture channel. Remove appropriate knockout(s) for power
supply entry.
Position the xture channel onto the ceiling and mark all appropriate mounting hole locations.
NOTE: Assistance will
be required for this step.
Punch a small hole in the ceiling at each marked location to see if there is a wood joist above that can be used to
mount the xture.
NOTE: For wood joist, use a suitable wood screw (not included) to mount the fixture. If there
is no joist to screw into, a 3/16” toggle bolt (not included) must be used to mount the fixture channel securely
to the ceiling. This product includes foam tape which may be used to seal any gaps between the fixture and
ceiling.
Connect the xture to a suitable ground in accordance to local electrical codes.
Connect the white ballast wire to the neutral power line wire with a wire nut.
Connect the black ballast wire to the hot power line wire with a wire nut.
Replace ballast cover by placing one edge of ballast cover into dimples, swing upward, and press cover allowing
second edge to catch second set of dimples and lock in place. Make sure no wires become crimped between cover
and xture.
Install the lamps (not included) by aligning the lamp pins with the socket slots, then pushing the pins all the way into
the socket slots and rotating the lamp until it clicks into place. Repeat for remaining lamps.
Install the diffuser by inserting one corner all the way into the corner of the wood frame. Bow the lens slightly and
insert the adjacent corner inside of the frame. Bow the lens on the longest edge sliding one corner inside of the
frame and then the last corner. Allow the diffuser to drop down and center the lens inside of the wood frame.
For re-lamping, remove the diffuser by sliding it to one corner, then slowly pulling the opposite corner of the diffuser
past the frame and guiding it out. Reverse step 8 for re-lamping.
3
2
1
8
9
CHANNEL
10
For 2x2, Use
type T8 high output
MAX 17 Watt
linear fluorescent lamp.
For 2x4, Use
type T8 high output
MAX 32 Watt
linear fluorescent lamp.
