5
Included are a cluster
of adapters, with raised
numbers on each arm
of the cluster. The
adapter marked #1
is the only adapter
needed to inflate your
Sea Eagle.
Take adapter num-
ber #1 and firmly
push it into the grey
tube in the end of
the hose. Make sure
that the adapter is
fully seated on the
tube by pushing it
until the end of the
tube pushes past
the raised ring in the
adapter.
Connect the other end
of the hose to the red
inflation port at the top
of the pump, located
near the ON and OFF
buttons.
ATTENTION:
Never
turn the dial when
the device is under
pressure as this will
immediately cause
the instrument to
break.
Connect the quick
connector at the end
of the power cord into
the quick connector
attached to the pump.
Hybrid SUP |
INFLATION:
Valves & Pumps
Adjust the pressure
dial to read between
12 and 15 PSI, the
operating pressure of
your Sea Eagle. PSI
is marked in red on
the dial.
To connect the pump
to a 12V battery, use
the cord with alligator
clips at the end of
the extension cord.
Connect the red clip to
the positive pole and
the black clip to the
negative pole.
WARNING:
Always
connect red clip to
the positive pole and
the black clip to the
negative pole.
Cross
connecting wires
could damage both
the pump and boat.