Sea Eagle FishSkiff FSK16, Инструкция и руководство пользователя

Страница: 11 / 20

10
FishSkiff | ASSEMBLY & INFLATION
Canopy (OPTIONAL)
Canopy kit includes two
curved bars, two side rods,
canvas, two black knobs
and two short (35mm)
screws. Additional
hardware may be included
that is not for use on the
FSK16.
Scotty® Deck Mounts
(OPTIONAL):
Attach deck mounts with
7/8” screws provided to
the pad mounts at the
bow & near the transom.
Screws are located in
Orange Repair Kit.
Arrow points inboard.
To install a Scotty
accessory in the mount,
push stem into base until
it clicks in.
Shown here is the Scotty®
Baitcaster Rod Holder.
An anchor mount is
suggested for the bow
pad.
Fold the canvas in half so
the shiny side is facing out
and the bars are lying on
top of each other.
Insert the side rods into the
curved bars until the
locking pins engage
through the holes.
Place the canopy on the
back of the boat with the
short bars up.
Use the short screw and
the knob to secure the rods
to the black canopy pads
on the boat.
Layout canvas upside
down (shiny side up).
Slide one curved bar into
the canvas sleeve with
locking holes up.
Slide the second bar into
the other sleeve with
locking holes facing down.
Attach the rear clips to the
rear carry handles.
Attach the front straps to
either set of carry handles.
Wrap the straps around
the rod twice to use the
handles directly below the
strap. Adjust the straps
until canopy is tight.
Don’t stab the pad!
Use only ¼ - 20 x 7/8” screws
provided in the orange repair
kit. Longer screws, pointed
screws, etc., will puncture the
air chamber.
Puncturing the air chamber in
this manner is not covered under
the warranty.
Caution: Puncture
hazard: do not thread screws
into base without the Scotty
Deck Mount.