7
FastCat | ASSEMBLY & INFLATION
Start with floor grommets.
Adjust transom board to
align the holes.
Transom Attachment
Hardware
4 - M8 x 100 Hex Head Screws
4 - 1” Flat Washers
4 - Threaded Knobs
Look through the
grommet hole to check
alignment with hole in
transom. Pull or push
bottom of side chamber
until holes line up.
A wrench is
recommended for
holding the bolt heads
while tightening the
threaded knob.
Insert screws with washer
through the side chamber
grommets and transom
holes
Motor Mount Transom Board
Insert transom board into
motor mount grommets.
Plate with ring faces f
orward.
WARNING:
Air compressors that are
designed for other uses
like tire inflation (usually
over 30 psi) can easily
over-inflate and cause
harm to your Sea Eagle
that uses a much lower
pressure. For this reason,
we recommend using only
Sea Eagle manual or
electric pumps.
Seat Bench Installation
FastCat12 can take two
aluminum crossbenches.
Each bench can take one
seat release and swivel
seat.
Pressure gauge will not
register until chamber
begins to get pressurized.
Pump until working
pressure of between 14
and 15 PSI is reached. Do
not exceed 15 PSI (1 bar).
Inner numbers in red show
pressure in PSI.