Sea-doo Islandia SE, Руководство оператора

Страница: 76 / 144

OPERATING INSTRUCTIONS
F04L0 7 Y
A
A
A. 90 cm (3 ft) of water under the hull
WARNING
In shallow water, shells, sand,
pebbles or other objects could be
drawn up by the jet pumps and be
thrown rearward.
As necessary, the exhaust system of
each engine should be flushed before
restarting to remove sand or shell ac-
cumulation which may clog the water
passages. Refer to
EXHAUST SYS-
TEM FLUSHING
in the
STORAGE
sec-
tion .
Shutting Off the Engines
To shut off the engines, completely
pull back throttle lever then remove
the DESS key or press the engine
start/stop switches.
Always remove the DESS key from the
DESS post.
WARNING
If engines are shut off, direction-
al control is not available. Never
leave the DESS key connected on
the DESS post when boat is not in
operation to avoid unauthorized
use by children, theft or others.
Post-Operation Care
WARNING
Allow engines to cool before per-
forming any maintenance.
General Care
Once boat is on trailer, unscrew the
drain plug, block the wheels and raise
the bow slightly with the trailer jack (if
so equipped) to allow water to drain.
Remove any remaining water that is
left in the engine compartment (bilge,
engines, etc.) with clean dry rags. This
is particularly important in salt water
use.
Remove the boat from the water every
day to prevent growth of marine organ-
isms.
Anticorrosion Treatment
To prevent corrosion, spray a corrosion
inhibitor (salt water resistant) such
as XP-S™ Lube (P/N 293 600 016) or
equivalent over metallic components
in engine compartment.
NOTE: Engine fogging should be done
with XP-S Lube (P/N 293 600 016)
whenever the boat is to be stored for
few days or a long period.
Apply dielectric grease (P/N 293 550
004) (salt water resistant) on battery
posts and cable connectors.
NOTICE
Never leave rags or tools
in the engine compartment or in the
bilge.
Additional Care for Foul
Water or Salt Water Use
When the boat is operated in foul water
and particularly in salt water, additional
care must be taken to protect the boat
and its components. Rinse trailer and
boat's hull/bilge area
with fresh water .
Flushing the exhaust systems with
fresh water is essential to neutralize
corroding effects of salt or other chem-
ical products present in water. It will
help to remove sand, salt, shells or
other particles in water jackets and/or
hoses.
74
______________