Sea-Bird Scientific SUNA V2, Руководство пользователя

Страница: 36 / 54

Acquisition file duration (min) 0–1440 60 afiledur
Data wavelength, low (nm) 210–350 217 wdat_low
Data wavelength, high (nm) 210–350 250 wdat_hgh
7.2.2 Data collection setup values
Parameter Possible values Default value Short name
Operation mode continuous, fixedtime, periodic, polled, SDI12 fixedtime opermode
Operation control duration, samples samples operctrl
Countdown (sec) 0–3600 3 countdwn
Fixed time duration (sec) 1–1000000 10 fixddura
Periodic interval 1, 2, 5, 6, 10, 15, 20, 30 (min);
1, 2, 3, 4, 6, 8, 12, 24 (hr) 1 hr perdival
Periodic offset (sec) any value 0 perdoffs
Periodic duration (sec) 0–255 10 perddura
Periodic samples (# light frames) 0–255 10 perdsmpl
Polled timeout (sec) 0–65535 10 polltout
Skip sleep at startup on, off off skpsleep
Lamp stability time (ds) ? 0–255 5 stbltime
Lamp switch-off temperature (°C) * (see note below) 35 lamptoff
Spectrometer integration period (msec) 5–60000 N/A spintper
Dark averages 1–200 1 drkavers
Light averages 1–200 1 lgtavers
Dark samples 1–65535 1 drksmpls
Light samples 1–65535 10 lgtsmpls
Dark duration (sec) 1–65535 10 drkdurat
Light duration (sec) 1–65535 120 lgtdurat
External device none, wiper none exdevtyp
Ext. dev. pre-run time (sec) 1–120 0 exdevper
Ext. dev. during collection on, off off exdevrun
Ext. dev. minimum interval 1–1440 60 exdvival
Periodic Mode of Operation : When power is supplied to the sensor, the sensor goes to a
low-power standby mode. Any activity on the input line puts the sensor to the "SUNA>"
command interface within three seconds. The sensor returns to low-power standby after a
user-selected period of time with no communication.
Continuous Mode of Operation : Data is collected continuously and autonomously when
power is supplied to the sensor. Data collection stops when the user removes power or
enters a "$" character.
Fixed-time Mode of Operation : data collection occurs for the time set up by the user.
When that time is completed, the sensor enters a low-power standby.
Polled Mode of Operation : the sensor is in low power standby mode until there is activity
on the input line. The sensor initializes in 3–4 seconds, then displays a "CMD?" prompt to
show that is it is ready to receive commands from the controller. The "timeout" value
Reference
34