SCUBAPRO-UWATEC Chromis, Руководство пользователя

Страница: 18 / 47

18
CHROMIS USER MANUAL
WARNING:
if you have set ppO
2
max to OFF, the planner
will allow depths up to maximum of
120m/394ft. Air/nitrox dives with high ppO
2
are extremely dangerous and can lead to fatal
injury. Be aware that exposures to high ppO
2
will lead CNS clock value to exceed maximum
recommended 100%.


NOTE: If MOD is shallower than
9m/30feet, planning is not allowed
and information LO MOD is shown.
By pressing SEL for planned depth the dive
time starts blinking. Start point (minimum
now) is the no decompression time. By
pr or – buttons you may change
the time in 1 minute increments. When
no decompression time is exceeded the
planner gives decompression time at the
bottom row.
By pressing SEL button the planner will exit
and you will get back to the main menu.
3.2.7 Using the Stopwatch
By pressing SEL button the stopwatch will
be activated.
In the fi rst display the stopwatch shows
the status, which can be stop, run or lap.
By activating the stopwatch fi rst time the
display will be as shown above.
Press + button and the stopwatch starts
counting and shows actual state which is:
run. By pr button again the stop
watch stops counting and shows actual
state: stop. The counted time will stay on
the display.
Stopwatch will reset the counted time
when + button is pressed and held.
The laps can be marked by pressing - button
when stopwatch is counting. By doing so
the display will freeze for 5 seconds and
Chromis shows the lap time.
Counting will continue automatic and lap
counter will show the number of laps at the
bottom of the screen.
By pressing SEL button you can exit the
stopwatch and return to the Stopwatch menu.


NOTE: You can leave the stopwatch
actively counting or you can leave
the stopped time to the display. The
status will be stored to a memory that
allows you to continue from the same
display at the next time.