SCS INTENSIVE 3A, Инструкция по установке и эксплуатации

Страница: 20 / 29

B
3.2 Transmitter memorizing
7
3.3 SYSTEM LEARNING AND LED DISPLAY
Before goes to system learning, the transmitter memorizing process has to be completed.
To complete the system learning, please following the instruction as below:
Step1: Press “SET”; then press “SET” + “DOWN” for 3 seconds, and the LED display shows “LEA”
Stop2: Press button (A) on time, the LED display should shows “ARN”
Step3: The gate will goes to Auto-learning, please wait for the learning process to be completed
Press “RF Learn” button for 3 seconds, and the LED3 is on; then press the transmitter button (A); the LED3 will blink
twice and then be off. The transmitter learning is completed.
C
A B
A B
LED Display Programmable Functions
“N-L”: The INTENSIVE3 system learning is not done.
“LEA”: Enter learning mode and then wait for learning instructions.
“ARN”: The system learning is in progress.
The Auto-learning process of gate moving:
“Gate open to the end- stop close to the end- stop.”
LED 3
3 Sec
LED 3
blink twice
LED 3 OFF
1
Press
1~3 Sec
Press
3 Sec
Push
1 2 3
4 5 6
2 3
12 13 14
LED1
LED2
LED3
ON
OFF
14
LED1
LED2
LED3
ON
OFF
2 3 4 5 6 7 8 9 10 11 12 13 14
LED1
LED2
LED3
ON
OFF
“RUN”: The INTENSIVE3 system is in normal operation
To set up the program, press SET button for 3 seconds, when the LED display change to F1-FA
press UP and DOWN to adjust the setting and press SET to confirm. When complete the setting,
just press button A on the remote or wait for few seconds for LED display change to “RUN” for
normal operation.