SERATO SCRATCH LIVE 3RD PARTY CONTROLLER QUICKSTART
1.9.0
2
PIONEER MEP-7000 &
SEP-C1
INSTALLATION
MAC
1. Connect your MEP-7000 or SEP-C1 to an
available USB port.
2. Your MEP-7000 or SEP-C1 will be detected
automatically and will be ready to use.
WINDOWS XP
1. Connect your MEP-7000 or SEP-C1 to an
available USB port.
2. You will see the following prompt from
Windows: “Can Windows connect to Windows
update to search for software?”
3. Select: “No, not this time”, click “next”.
4. Select: “Install automatically”, click “next”.
5. Windows will then notify you that it has “Found
new Hardware PIONEER SDJ-C1 CONTROL”
followed by “USB composite device”.
6. You will be prompted to install 2 drivers. “USB
composite device” and “USB audio device”.
Follow the prompts as per the usual driver
installation method for Windows.
WINDOWS VISTA
1. Connect your MEP-7000 or SEP-C1 to an
available USB port.
2. You will see the following prompt from Windows:
“Windows needs to install driver software for
your PIONEER SDJ-C1 CONTROL”.
3. Select “Cancel”.
SETUP
1. Start Scratch LIVE and switch both decks to
internal mode.
2. You will now be able to control Scratch LIVE
with your MEP-7000 or SEP-C1.
BASIC OPERATION
To select and load tracks use the KNOB (23)
to scroll through your crates and tracks. By
pressing the KNOB you can jump between your
crate and track libraries. Use the LOAD button
(21) to load a track to the virtual deck.
PLAYBACK
Use the PLAY/PAUSE button (19) to play and
pause your tracks. You can control the speed
of the braking as normal in the setup menu of
Scratch LIVE.
USING CUES
You can set the first cue point using the MEMORY
button (2). You can then delete the cue point by
holding down the MEMORY button. Press the
CALL button (3) to trigger the first cue point.
You can set a temporary cue point at the current
position of the playhead by pressing the CUE
button (18) while playback is paused. Holding
the CUE button will then play from the temporary
cue point.
USING LOOPS
You can create loops by using the IN/CUE button
(5) to set the loop in-point and the OUT/ADJUST
button (6) to set the loop out-point. Once looping
you can press the OUT/ADJUST button again
which then allows you to use the JOG WHEEL
to adjust the loop out-point manually. Press the
OUT/ADJUST button again to set the new loop
out-point. Use the RELOOP/EXIT button (7) to
jump to the start of the loop and turn looping on
or to turn looping off if it is already looping.
