KS-10
VHF Marine Antenna 22 cm (9”) length
Code: PF AN NVHF00025
Mounting instructions
ENG
1 - Choose the surface on which to install the antenna, the surface
must be even and with a thickness not exceeding 25 mm.
•
The antenna should be installed in the place where is an all
round clear view of the horizon and as high as possible.
•
Please keep clear the antenna from any obstacles.
•
The surface material is irrelevant for the purpose of installation,
preferably metallic.
2 - Use the mounting template (that you’ll find at the end of this page)
to drill the four holes on the surface.
6 - Run the unipolar white cable and fasten it to its end using a self-
tapping screw, in case you can use adhesive tape to help yourself.
If the antenna is installed on a metal surface, the use of the ground
cable can be avoided, so it is possible to cut it.
Here follow some installation examples.
Scout S.r.l.
Via Enrico Fermi 90 - 41010 Limidi di Soliera MO - Italy - VAT nr. IT03625890367
Tel. +39 059 566650 - [email protected] - www.scoutantenne.com
3 - Set the antenna on the surface and secure it with the three self-
tapping screw included in the packaging.
4 - Connect the cable bundle to the antenna unit and secure it with
the supplied nut. Now you can cut off the excess central termination
as shown in the image below.
5 - You can now cover the connection with the supplied rubber boot.
OK
Attention:
DO NOT lay the ground cable along the path of the com-
munication cable as shown below.
NO
OK
7 - Finally you can mount the supplied PL connector on the end of the
coaxial cable and connect it to the VHF radio device.
KS-10 mounting template
Drill hole
8 mm (0.3 in)
56 mm (2.2 in)
Drill hole
Drill hole
Drill hole
