Scott Edge Reinforcer, Инструкция по эксплуатации

Страница: 57 / 117

4 Maintenance
4--8
Edge Reinforcer Issue 1
A
B
Fig. 4-7. Replacing Cut Off Knives
4.1.3 Replacing Cut--Off Knives
The cut--off knives are removed by loosening the
two set screws in the upper (A) and lower knife (B)
holders. You will notice that in the upper knife
holder there is a small piece of sheet metal which
is called the “knife shim”. Anytime you need to
replace the knives, put in a new “knife shim”. It is
held in position by the upper knife blade.
A C D
Fig. 4-8. Make Sure That Upper Blade Does Not
Touch Ring or Springs
Care should be taken when replacing
the upper cut- off knife (A) to make
certain that the knife is not in contact
with the ring (C) which holds the upper
drive ring or with the extension springs
(D) on the other end of the knife.
CAUTION!
IMPORTANT: After the new knives have been
inserted and tightened, turn the machine over
by hand several times to make sure the knives
are meshing properly.