8
9
SOAP REFILL BOTTLE INSTALLATION
AND REMOVAL INSTRUCTIONS
USER GUIDE FOR THE SCOTT
®
ELECTRONIC COUNTER MOUNT
FOAM SKIN CARE DISPENSER
LED INDICATORS:
There are several indicator LED’s on the soap
discharge head which are used as follows:
Yellow LED (Low Product)
– The yellow LED will
begin to flash slowly (1 time every second) when
the soap refill has between 50 and 90 shots of
soap remaining.
Red LED (Low Battery) slow flash –
The red
LED will begin to flash slowly (1 time every
second) when battery power remaining is
sufficient for approximately 500 additional shots
of soap.
Red LED (Low Battery) rapid flash –
The red LED will begin to flash rapidly (4 times every
second) when battery power is not sufficient to activate the dispenser. Replace batteries.
Red LED (Motor Short) –
The red LED will begin to flash 2 times every second. Reboot the
dispenser by disconnecting and reconnecting the power.
Note:
• When power is supplied to the system prior to installing a soap refill, the red and yellow LED
will flash, indicating a good power connection has been established. It will continue to flash
until a soap refill is installed.
• When a soap refill is properly loaded into the dispenser the red and yellow LED will stop
flashing indicating the refill is properly installed.
Yellow LED
Red LED
Slip the straw into the underside of the
motor module (Figure 1).
Push the refill bottle flush to the motor
module until both snaps are secure
(Figure 2).
Note:
When power is supplied to the
system prior to installing a soap refill, the
red and yellow LEDs will flash indicating
a good power connection has been
established. The LEDs will continue to
flash until a soap refill is installed.
When a soap refill is properly loaded
into the dispenser the red and yellow
LEDs will stop flashing indicating the
refill is properly installed.
Prime the pump by placing one hand
under the soap discharge head to
activate the motor. Repeat 4 to 5 times
until a consistent shot of foam soap is
discharged (Figure 3).
To remove an empty refill bottle,
squeeze the release tabs 1 on the top
of the refill and slide the bottle down 2
and out (Figure 4).
A
B
C
D
1
Snap 1
Snap 2
2
3
2
1
1
4
