4
5
Position template over hole in counter
positioning discharge head so soap
will discharge into sink. Peel adhesive
backing off above counter spacer, align
with opening in template and press
down firmly to secure to countertop
(Figure 7).
Insert the support shaft through the hole
in the above counter spacer aligning the
support shaft with the spacer (Figure 8).
Remove template and discard.
Remove the adhesive liner from the
plastic support ring and from the
underside of the countertop, slide it thru
the support shaft and push it up until it
sticks to the underside of the countertop
(Figure 9).
Note:
If the support ring will not sit flush
with the underside of the countertop
due to interference with the sink, use
the optional split support ring provided
instead.
IMPORTANT – USING A PHILLIPS
BIT IN A POWER DRIVER, TIGHTEN
AT FULL SPEED THE 2 SCREWS
ON THE SUPPORT SHAFT UNTIL
THE PLASTIC HEADS BREAK AWAY.
REMOVE THE REMAINS OF THE
WHITE PLASTIC HEADS FROM THE
SUPPORT SHAFT (Figure 10).
H
I
J
K
Use the hand tool provided to complete
the tightening of the support shaft. Tighten
in a clockwise direction (Figure 11).
Push the signal cable attached to the
soap discharge head thru the opening in
the support shaft (Figure 12).
Align the notches on the bottom of the
soap discharge head with the tabs on the
support shaft (Figure 13).
Rotate the soap discharge head counter
clockwise until the tab on the soap
discharge head is aligned with the rear
tab on the support shaft (Figure 14).
Important – Using the Allen wrench
provided, tighten the set screw clockwise
on the back of the soap discharge head
until it is tight. The head of the set screw
should be flush with the surface of the
soap discharge head. (Figure 15).
IMPORTANT – APPLY A BEAD OF
CLEAN SILICONE CAULK AROUND
THE PERIMETER OF THE SOAP
DISCHARGE HEAD OR THE ABOVE
COUNTER SPACE, IF USED (Figure 16).
L
M
N
O
P
Q
7
8
9
10
11
15
12
16
13
14
