Scott Safety Protege, Руководство пользователя

Страница: 73 / 104

Maintaining the Device
49
SCOTT SAFETY 087-0038 REV L
10
Use the can of compressed air to blow the excess isopropyl alcohol from the pump.
The thin tube that comes with the can of air may be helpful in directing the air
stream into the pump ports. The pump should make an audible whir as it spins.
11
Re-attach the pump tubing to the INLET (long) and OUTLET (short) ports.
12
Place the pump assembly into the enclosure with the ports positioned over top of
one another. The OUTLET port should be on top and the INLET port should be on
the bottom. Verify the wires are routed on top of the assembly. See
Figure 38 .
Figure 38 Routing the Pump Wires
13
Insert the pump retaining plate.
14
Place the pump inlet barb into the pump enclosure groove. See Figure 39 .
Wires Routed
on Top of Pump
Inlet Port
Outlet Port